MegaSquirtPNP G2 NJ8994 for the Nissan S13 SR20DET, manual trans

MegaSquirtPNP Gen 2 Plug-N-Play Standalone Engine Management System MegaSquirtPNP Model #NJ8994 Features 1989-1994 Nissan S13 SR20DET with manual tranny - also perfect for 240SXs with this swap! New second generation MSPNP! We've totally redesigned the MSPNP! This new second generation unit runs MS2/Extra sequential code, using the MicroSquirt Module and a lot of new MSPNP-specific hardware. We've added several major improvements over the original. Here's the features of the new model. Easy to Use and Install! Fully Plug and Play Installation - No wiring required for basic functionality except the included air temperature sensor.
Average install time is under 1 hour!
SR20DET base maps is pre-loaded to help your engine start on the first turn of the key
Real time tuning and data logging with a laptop connection
Supports most aftermarket wideband sensors
Fully Tunable Engine Control! 16x16 Fuel Tables allow high resolution tuning
12x12 Ignition Tables
Multiple Acceleration enrichment strategies
Closed Loop Idle Speed Control
Air Conditioner Control
Up to 4 sequential fuel injector channels with individual trim tables (optional trigger disc required for sequential injection)
Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
Allows removal of stock airflow meter
Advanced Feature Set (Included!) 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
Built-in 2-step rev limiter / launch control with flat shift
Real time barometric correction
Internal 4-bar MAP sensor reads up to 44PSI of boost
Overboost protection
Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
Knock sensor input with adjustable sensitivity
Headphone output for knock sensor - listen for knock while you tune!
Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
Input for flex fuel sensor - switch between E85 and gasoline on the fly!
CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless! Note: Installation of an IAT sensor and trigger disc is required. Both are included with this ECU. What you get in the box: MegaSquirtPNP NJ8994 ECU MSPNP RS232 serial tuning cable, 6' (USB adapter sold separately, if needed) Tuning Software and Documentation CD 6' Vacuum Hose for MAP Signal and 'T' fitting IAT sensor and wires
Four Screws for ECU mounting Bolt in optical trigger disc for stock CAS