Wiring Specialties Pre-Made 1JZGTE Non VVTI into S14 240sx Harness

Looking for the best in aesthetics, weight savings and reliability out of your harness? Our Pro Series harness completely replaces your old OEM harness so you can forget about those electrical gremlins.

This Wiring Specialties PRO Series harness was designed from the ground-up to exceed OEM specifications for wire quality, power/ground routing. With our optimized and 'tucked' approach the end result will be a clean and worry free installation with a guaranteed start up.

This harness is specifically engineered for a USDM LHD S14 Nissan 240sx (95-98) with the 1JZGTE non-VVTi engine swap. It was developed in house on an actual 1JZGTE non-VVTi engine in an S14 240sx chassis to ensure a perfect fit to all engine connections.

Wiring Specialties offers a number of options for common performance upgrades for this product. Build your perfect harness by selecting from the available options to the right, and as always - if you have any questions, please reach out to us.

• Any non-VVTI 1JZGTE from MKIII Supra
  
• Any non-VVTI 1JZGTE from Chaser/Mark II
• Any non-VVTI 1JZGTE from Soarer/Crown
• For GM/LQ9 coils – upgrade should be used with an aftermarket ECU and run sequentially. OEM ECUs require an IGF signal produced by the ignition chip. When the chip is removed for LQ9 coil installation, an aftermarket ECU or IGF simulator box is required.

• Any USDM LHD S14 240SX manufactured in 1995-1998
• Factory Tachometer use requires the Dakota Digital Signal Conditioner Box SGi-8.
• Factory Speedometer use requires the Dakota Digital Signal Conditioner Box SGi-5.
• Factory Coolant Temp gauge functionality requires the S-chassis OEM 1-pin coolant temp switch to be used in the JZ’s coolant elbow.
• A/C wiring utilizes stock S-Chassis fuse box AC relay and wiring. The JZ AC compressor connector must be wired to the chassis’ output AC signal wire.
• Alternator Warning light and Oil Pressure Warning light remain functional.

PRO-SERIES HARNESS TECHNICAL SPECS

• Plug and Play – simple and efficient
• NO CORE HARNESS or additional wiring required
• OEM wire colors used, where applicable
• All sensor signal connections use EM shielded wires
• Fireproof fiberglass sleeving used in high-temp sections near the manifold & turbo (-40°C/-40°F to +450°C/+845°F operating temperature)
• Point-to-Point continuity tested on every wire
• Constructed using exact OEM connectors and seals
• Made with high temp TXL wire with adhesive shrink tubing (-40°C/-40°F to +125°C/+257°F operating temperature)
• Wrapped in lightweight nylon loom (-94°C/-137°F to +125°C/+257°F operating temperature)
• Includes a charge harness and improved grounds
• Fully tested after production for an easy plug-and-play installation