Wiring Specialties RB25DET Wiring Harness for S13 240sx - PRO SERIES

Wiring Specialties - RB25DET PRO SERIES Wiring Harness for S13 240sx (WRS-PRORB25-S13)

This Wiring Specialties Pro Series Wiring Harness includes the engine and transmission harnesses for a Nissan 240sx S13 with an RB25DET engine swap. It was developed in house on an actual RB25DET engine and comes tucked for a clean finish. The harnesses uses all OEM connectors and is built to proper OEM specs including wire length and gauge. 

Note: Photos are not of actual product. Please check back for new photos.

PRO-SERIES HARNESS SPECS 

• Plug and Play.
• No cores or additional wiring required.
• Point to Point continuity tested on every wire.
• Constructed using OEM connectors and seals.
• Made with high temp TXL wire (-40C to +125C operating temperature) with adhesive shrink tubing.
• Wrapped in lightweight nylon loom with -94C to +257C operating temperature.
• Includes a charge harness and improved grounds.

PRO-SERIES HARNESS INCLUDES 

• Quick disconnect MAFS/AEM/Haltech/PFC Speed density extensions (change from MAFS TO AEM/Haltech in seconds).
• Coil harness sub-harness.
• Knock sensor sub-harness.
• Transmission harness with reverse and speed sensor wiring.
• Alternator charge cable.
• Nissan Diagnostics connector.
• S13 Power and dash interface connectors.
• Retains factory A/C,speedometer, tachometer, engine temperature gauge, oil pressure sensor, alternator charge light, reverse lights and wipers.

Our Pro-Series is ideal for those looking for the best aesthetics, weight savings and reliability. Completely replace your old harness and forget about electrical gremlins